Dogtra eF-3000 Gold - Manual (Page 10)

17 16
INSTALLATION
1. To ensure that your system is working properly,
connect the transmitter adaptor into the adaptor of the transmitter and
then plug the adaptor into a household outlet. Switch the stimulation knob
to Pager+Stimulation, or Stimulation Only. The ON/OFF indicator light
should turn on.
2. Unwind the length of ground wire that was provided and strip about 1/2
inch off each end. Insert both ends of the ground wire into the outer, red
wire connector jacks, leaving the center jack free. If the wires are
connected properly, the wire indicator light will be on.
3. Next, activate the collar/receiver by turning the intensity level dial on the
receiver to the desired level. The LED light will blink once every two
seconds showing that it is on.
If not activated for 10 seconds or more, the system will go into sleep
mode.
4. Hold the receiver in your hand with the contact points facing up. Place
the test lamp over the contact points and approach the test loop.
5. Watch for the test light to come on and/or the unit will emit the warning
vibration if the unit is in this mode at the wall mount transmitter.
Be careful not to touch the contact points as the unit will emit stimulation
when activated.
TESTING YOUR
PRIOR TO INSTALLATION
TESTING
Fence Wire
The fence wire must make a continuous loop around your property for
your system to operate. The signal is delivered from the terminal of the
transmitter, through the fence wire, back to the other terminal on the
transmitter. When this is accomplished, the wire continuity light will emit
a constant red indicator.
INSTALLATION