Bissell 65A8 - Manual (Page 8)

16
w w w . b i s s e l l . c o m
8
Carpet Refresher Attachment (select models)
this accessory is recommended for the
refreshing of carpets. once the Steam mop max
is cradled in the carpet refresher attachment, it
will easily glide over the carpet.
notE: Always be sure a mop pad is in place
before placing in carpet refresher attachment.
only white mop pads should be used with
the carpet attachment. Do not use carpet
attachment on spots or stains or glide it over
the same spot for longer than 20 seconds.
1. Attach the mop pad to the swivel mop head as
directed in step 1 on page 6.
2. Place the swivel mop head, with a white mop
pad attached, in the carpet refresher attachment.
note: the Steam mop max rests in the carpet
refresher attachment and may not stay attached
to the swivel mop head. It is meant to glide over
the carpet.
3. Fill the water tank with water. Begin refreshing
your carpet or rug by pushing the Steam Mop
Max in a forward and backward motion,
releasing steam as you go.
4. When you have finished refreshing your carpet
or rug, unplug the Steam Mop Max and remove
from the carpet or rug.
notE: move the Steam mop max and carpet
refresher attachment in a continuous motion
until you are finished. this product is not
intended to be used as a carpet cleaner, only a
carpet refresher or deodorizer. never attempt to
use the Steam mop max on carpet without the
carpet refresher attachment in place. Do not
leave the Steam mop in a stationary position.
When you're done
1. Unplug power cord from outlet.
2. Carefully remove mop pad from swivel head, as
mop pad and lower assembly will be hot.
3. Any water remaining in the water tank should
be emptied prior to machine storage.
4. Mop pad can be machine washed in hot water.
Tumble dry on low heat or air dry.
5. Wrap power cord around Quick Release cord
wrap on side of Steam Mop.
O
peration
cAUtIon:
Upright storage of the
Steam mop max with a wet
mop pad may result in the
formation of white marks on
your floor. to remove the
white marks, clean area
with vinegar.
Tip:
Using distilled or demineralized
water will maximize the
performance of your filter.
Tip:
During first use, it may take several
seconds for the Steam Mop to begin
steaming. The water needs to flow
through the filter to the heater. This delay
will only occur during initial use or when
using a new filter.
M
aintenance and care
2
3