Bissell 6355E - Manual (Page 11)

w w w. b i s s e l l . c o m
11
M
aintenance and care
clearing a clog
low suction or poor pickup may be
due to a clog in the vacuum. if you
notice a change in the sound of the
vacuum motor, check for clogs.
1. Turn power OFF. Unplug vacuum cord
from electrical outlet.
2. Empty dirt container.
3. Check upper tank and suction inlet for clogs.
4. Grasp Hose Wand and remove hose
wand from base to check for clogs in
the base, the wand, and the hose.
5. Remove the screw attaching the hose
wand base to the vacuum. Straighten
the hose wand base and unclog
with long, narrow object such as
broom stick.
6. If the clog persists, follow steps for
checking rotating floor brush on page
10 and inspect the air passageway
for obstructions.
turbobrush tool maintenance
1. Turn power OFF. Unplug vacuum
cord from electrical outlet.
2. Remove tool from hose or from clip
on vacuum handle.
3. Twist collar so opening is at the top
and lift clear cover to remove.
4. Remove brush from belt and
clean debris.
5. Replace brush inside belt and place
ends into slots on the sides.
6. Reposition top cover making sure to l
ine up inside tab at the front with the
opening on the cover. Twist collar
until opening is at the bottom to lock
into place.
3.
5.
Remove
Screw
3.
5.
Suction
inlet