Bissell 15D6e - Manual (Page 9)

w w w . b i s s e l l . c o m
9
M
aintenance and care
1. Unplug the vacuum from electrical outlet.
2. The foam motor filter protects the motor
from dirt particles. It is located in the
slide out tray underneath the dirt con-
tainer. If the filter becomes dirty, pull out
the tray, lift out the foam filter pad and
clean it.
NOTE: The foam motor filter may
be hand washed in cold water
with mild detergent. Rinse well
and air dry thoroughly before
replacing.
3. The HEPA media filter* assists in the
filtration process to return clean air to
the room. It is located beneath the pre-
motor filter in the slide out tray housed
underneath the dirt
container. If the filter becomes dirty,
remove the tray, remove and replace
the HEPA media filter*.
NOTE: The HEPA media filter* is
white pleated filter. This filter
is NOT washable and must be
replaced when it becomes dirty
Thermal Protector
An internal thermal protector has
been designed into your vacuum
toprotect it from overheating. When
the thermal protector activates, the
vacuum motor will stop operating. If
this happens:
1. Turn the vacuum OFF and unplug from
electrical outlet.
2. Empty the dirt container, check filters
and air passages for dirt accumulation.
3. The thermal protector automatically
resets after approximately one hour. If
the thermal protector does not reset, call
BISSELL Consumer Services.
Cleaning the foam motor and HEPA media filter*
WARNING:
Do not operate cleaner with
damp or wet filters or without
all filters in place.
2
Foam-motor
Filter
Filter (under
foam motor
filter)
NOTICE:
This product is intended for household
use only and not for commercial or
industrial use. Vacuuming of dust
from products like plaster, concrete
or ashes will damage the motor and
void the warranty.
* The filter media, not the vacuum as a whole,
complies with the IEST-RP-CC001.5 HEPA Standard.