Bissell 15D6e - Manual (Page 5)

w w w . b i s s e l l . c o m
a
ssembly
The only tool you’ll need to assemble
your vacuum is a screwdriver.
Attach handle to vacuum
1. Locate the vacuum handle and remove
the screw packet taped to the handle.
2. Stand the vacuum upright and from the
rear of the unit, slide the base of the
handle firmly into the grooves at the top
of the vacuum body.
3. Ensure the handle fits firmly to the vacu-
um body. If there are any gaps, continue
to push firmly until the handle is secure.
4. Insert the provided screw into the exist-
ing hole, attaching the handle to the
body of the vacuum. Tighten securely
with a screwdriver.
Attach vacuum hose and tools
1. Slide the end of the hose into the hose wand
base. Snap the hose into the hose clip.
Note: The vacuum will not operate
effectively unless the hose wand is
firmly attached.
2. Place the crevice tool on the storage clip
on the left side of the tank (when viewing
vacuum from rear.)
3. Place the dusting brush on the storage
clip located on the lower cord wrap.
4. Wrap power cord around cord wraps.
5
2
1
4
3
4
2