Bissell 4757e - Manual (Page 8)

w w w. b i s s e l l . c o m
M
aintenance and care
8
8. Insert the dirt cup filter assembly back into
the dirt cup by lining up the tabs on the top
of the dirt cup filter assembly with the notch-
es inside the top of the dirt cup and turning
the handle on the bottom of the dirt cup
filter assembly clockwise to lock into place.
Replacing the post-motor filter
the post-motor filter assists in the
filtration process to return cleaner air to
the room. use only bissell replacement
filters in your cleanView Pet compact.
1. Unplug the vacuum from electrical outlet.
2. Remove the filter door (located on the back
of the vacuum) by pushing down on the tab
and pulling out and away from the vacuum.
3. The post-motor filter can be hand washed
in cold water with a mild detergent. Rinse
well and air dry thoroughly before placing
back into the vacuum.
4. Replace the filter door by placing the tabs
on the bottom of the filter door into the
notches on the bottom of the post-motor filter
compartment and pushing the tab forward
back into the vacuum to lock into place.
clearing clogs from the dirt cup
1. Unplug the vacuum from electrical outlet.
2. Remove the dirt cup from the vacuum, following
steps 1-3 of emptying the dirt cup on page 6.
3. Remove the dirt cup filter assembly from the
dirt cup, following step 2 of Clean the dirt
cup filter on page 7.
cleaning the dirt cup filter continued
notice:
This product is intended for household use
only and not for commercial or industrial
use. Vacuuming of dust from products like
plaster, concrete or ashes will damage the
motor and void the warranty.
Tip:
For maximum cleaning performance,
check the filters often and clean or
replace if necessary.
WaRning:
Do not operate cleaner with
damp or wet filters or without
all filters in place.
2.