Bissell 44L6E - Manual (Page 11)

w w w . b i s s e l l . c o m
11
o
perations
Ready Tools™ continued
9. Clean by pressing the spray trigger to spray
solution onto the area to be cleaned. Slowly
move the tool back and forth over the soiled
surface. Release the spray trigger to suction
dirty water. Continue to clean in the area,
working in small sections, until dirt is removed.
Caution: Do Not Overwet.
10. When finished cleaning, remove and rinse
tool(s) in clean, running water.
11. It is recommended that you suction clean
water from a bowl to rinse out the hose.
12. Before wrapping hose onto tool rack, lift end
of hose and stretch out to ensure all water is
cleared from hose.
13. Wrap flex hose around tool rack.
14. Empty 2-in-1 water tank and rinse out,
following instructions on pages 9 through 10.
15. If the ReadyTools dial becomes difficult to
turn, the diverter assembly that holds the
dial may need to be cleaned. To clean,
first remove nozzle and locate screw that
holds the diverter assembly in place. With a
Phillips screwdriver, remove the screw and
set aside.
16. Remove diverter assembly; hold under run-
ning water making sure water flows through
and around the dial. Turn the dial about 10
times clockwise and 10 more times counter
clockwise. This should free up any debris.
17. Wipe diverter assembly with a soft cloth and
replace back on machine. Replace nozzle.
18. Return ReadyTools dial to
FLOOR CLEANING setting.
Cleaning with Deep Reach™ Tool
(select models only)
1. Set tool on soiled surfaces and press the
spray trigger to spray solution onto the
soiled area to be cleaned.
2. Slowly move the tool back and forth over
the soiled surface, keeping the tool in con-
tact with the carpet.
Release spray trigger and move tool
slowly over the soiled area to suction up
water and dirt.
4. Continue to clean the area, working in small
sections, until no more dirt can be removed.
15.
12.
16.
Screw
Run water through here
11.
1.
3.