Humboldt HM-2800 Multi-Speed Load Frame - Manual (Page 5)

Electrical Connections
Place unit on a flat smooth surface and use leveling feet (supplied) and
a bubble level to ensure that the unit is level side-to-side and back-to-
front.
Electrical Connections
The HM-2800 arrives ready for operation. Attach the supplied IEC
electrical cord to the machine and plug into a standard wall receptacle
for use in the United States.
The 220 50/60Hz variation of the HM-2800, the HM-2800.4F includes a
step-down transformer, which allows the HM-2800 to be used with 220
50/60Hz applications. The step-down transformer is a external device,
which comes pre-wired with a supplied cable but no plug. The cable
can be used to hard-wire the transformer to your 220 50/60Hz source,
or you can install an appropriate plug. The transformer can then be
plugged into the HM-2800 with the supplied cable.
Power Cord:
Your Multi-use Test Machine is fitted with a molded vinyl grounding
plug. The cord is made of three conductors either
(American color coding).
Green Ground (Earth)
White Cold (Neutral)
Black Hot (Live)
or
(International color coding).
Green/Yellow Ground (Earth)
Blue Cold (Neutral)
Brown Hot (Live)
Fuses:
The Master Loader uses (2) 5x20mm, slo-blow fuses in the IEC power
entry module at the right rear of the machine. The replacement part
number for these fuses is H-1322.13.
4