Humboldt H-1322B Marshall and TSR Compression Machine - Manual (Page 5)

Physical Specification
Net weight: 226 lbs . (110 kg)
Shipping weight: 266 lbs . (113 .6 kg)
Overall height: 39"
Base dimension: 35"x18"x10"
Power Supply
110 VAC 60 Hz 1 phase (H-1322B), 975 watts
220 VAC 60 Hz 1 phase (H-1322B .2F), 975 watts
220 V AC 50 Hz 1 phase (H-1322B .5F), 975 watts
Check that your machine has the correct voltage for your local supply .
Power Cord
Your Marshall & TSR Test Machine is fitted with a fused IEC receptacle and
cord with molded vinyl-grounding plug . The cord is made of three conductors:
(American color-coding)
Green Ground (Earth)
White Cold (Neutral)
Black Hot (Live)
or
(European color coding)
Green /Yellow Ground (Earth)
Blue Cold (Neutral)
Brown Hot (Live)
Fuses
The Marshall Test Machine uses a slo-blow fuse that is fitted into the rear of
the machine . The replacement part a 5 x 20 mm 10A, 250V ceramic (or glass) .
Initial Installation
Remove the packing list and verify that all parts have been received . Normally you
will receive one crate comprised of compression and recorder frame, with calibrated
load cell (HM-2300 .100) 10,000lbf capacity (44kN) fastened to it, 100 charts
(H-1322CP), 6 pens, a DB9 serial cable, and this user manual .
Set the machine base up at the place it is to be used in the laboratory and then
check that it is level by placing a spirit level on the platen . If it is not level, adjust the
feet of the machine .
Operation
Control Panel
The control panel is situated on the front right hand side of the machine base .
Recorder range and pen controls are on the recorder's chart plate .
Preset Speed of Platen:
2 .00 in/min . (50 .80mm/min .)
3