Crimestopper Security Products SP-500 - Manual (Page 9)

9
WIRING: 5-PIN Connector (Trigger Inputs)
Violet: (+) Door Pin Switch Input
Same as the GREEN wire below except this wire is used for vehicles that show a positive voltage (+12 volts) when
the door is open and a ground when doors are closed as in many Ford, Lincoln, and Mercury vehicles.
Green: (-) Door Pin Switch Input
Identify the wire that reads ground when any door is open and 12 volts when all doors are closed. Some vehicles
may have isolated door triggers. In this case you may need to run additional wires from other doors or go directly to
the wire that triggers the vehicle’s interior dome light. Sometimes newer vehicles contain a separate body control
module (BCM) where the door trigger circuit can be located. Most vehicles will NOT require the use of BOTH Green
and Violet door trigger wires.
Blue: (-) Hood/Trunk Pin Switch Input
Input trigger for a grounding hood or trunk pin switch. Connect to existing hood and trunk pin switches that read
ground when open. If no existing switches are available, install new pin switches if desired. Note: DO NOT mount
new pin switches in water pathways.
Pink: (+12V) +/- Diesel Glow Plug Input or Passive Carjack Input (Programmable Input Wire)
+/- Trigger: See diagram (Pg. 29) for Jumper Pin Configuration.
+/- Glow Plug Input (Diesel Vehicles Only)
Connect Pink wire to indicator circuit that shows a (- or +) Signal while the “WAIT TO START LAMP” is on.
When this wire is used, the system will wait until light turns off before attempting a remote start.
Passive Carjack Trigger
When using Carjack protection, connect this Pink wire to a (+ or -) toggle switch, or +12V ignition source
depending on your level of Carjack protection. When +12V is applied to this wire with the IGN on, then Carjack
is armed. If a door is opened then closed with ignition on, the Carjack countdown will begin. See Diagram
Below for wiring configurations. DO NOT connect the Pink Carjack wire to Ignition unless there is extreme
danger of a Carjack. When using the Ignition, Carjack is armed all the time and must be reset each time a
door is opened and closed.