Motorola walkie talkie - Manual (Page 8)

En
gl
is
h
6
Direct Charge:
1. Connect the DC adapter’s plug to the radio’s
DC IN 9V jack and plug the other end to a
vehicle's accessory power outlet.
Using the Charging Cradle:
1. Connect the AC adapter to DC IN 9V and to
a standard electrical outlet.
2. Set the charging cradle on the desk or
tabletop, and place the radio in the charging
cradle with the keypad facing forward.
3. Make sure that the LED illuminates. Charge
the battery pack for 16 hours and remove the
radio from the charging cradle after charge.
Note:The charge indicator LEDs will remain
on as long as the radios are left in the
charger.
Charging the battery
You can charge the NiMH battery pack itself
using the included battery support bracket.
1. Place the battery support bracket into the
charging cradle.
2. Install the NiMH battery pack applying its
charging contacts to those of charging
cradle. Installing the batteries incorrectly will
prevent the unit from charging.
3. Make sure that the LED illuminates. Charge
the battery pack for 16 hours .
Note:The charge indicator LEDs will remain
on as long as the radios are left in the
charger.
Using the Radio
In order to get the most out of your new radio,
read this reference guide completely before
attempting to operate the unit.
Turning the Radio On and Adjusting the
Volume
1. Press and hold the MENU/
key to turn the
radio ON, and increase the volume by
pressing the
key. To decrease the
volume, press the key.
2. Press and hold the MENU/ key again to
turn the radio OFF.
MOTO 7794.book Page 6 Tuesday, June 29, 2010 3:16 PM