B&G H5000 Pilot Controller User Manual
Page 2
Installation
1:
Find a suitable location for the module.
Mount the module vertically. Ensure that there is at least 100
mm clearance between the connector and grommet and any
surface to enable easy access to cables
2:
Mark the hole positions, drill pilot holes and fi x into
position with two self tapping screws
3:
To remove the lid, unscrew the two lid screws.
Note:
The lid hinges at the bottom edge of the
module. To close the lid you need to locate the
bottom edge fi rst.
4:
Cut the grommet indicated to a length that creates a tight
fi t for the cable to be fed. Feed the cable through and wire
into the module plug.
Ensure the cables are positioned to the left of the center
pillar and the plug can reach the connectors without placing
tension on the wires.
Module jumpers
If a sensor or combination of sensors connected to an Analog Module draw more
than 300 mA current total, then a terminal link must be placed onto both jumpers
located above the network connector inside the module as shown below. This
bypasses the isolated power supply within the module.
Note:
Do not bypass the isolated power supply unless necessary
Wiring
Below is an example of how to wire an Analog Module with a masthead unit and
paddle wheel sensor.
Connector A
Connector B
Conn
nn
nn
nn
nn
nn
nn
nn
nn
n
nn
n
nn
nn
nn
nn
nn
nn
n
n
nn
n
n
nn
n
n
nn
nn
n
n
nn
nn
n
nn
ector
Connector A
Connector B
Masthead Unit
Paddlewheel Sensor
1 Screen
1 Screen
2 Orange
2 -
3 Black
3 Black
4 -
4 Red
5 Blue
5 -
6 Green
6 -
7 Red
7 -
8 Violet
8 Green
Terminal A
Terminal B
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
Terminal A & B
Connector
1
Screen
2
12 V
3
0 V
4
5 V
5
0 - 5 V input
6
0 - 5 V input
7
0 - 5 V input
8
Pulse 1