Aphex DUAL RPA 500 - Manual (Page 3)

Page 4 Page 5
1. Turn off and unplug your 500 series rack frame. Inspect the
card slots you intend to use to make sure that they are clean and
free of any debris.
2. Before removing your DUAL RPA 500 from its box, discharge
any static electricity buildup you may have by touching your
500 series rack.
3. Pull your DUAL RPA 500 module out of its box and carefully
slide it into place in the designated opening. Sight down the
back of the module (use a flashlight if necessary) and ensure
the card edge connector is aligned to seat into the card slot of
the frame.
4. Firmly and evenly push the DUAL RPA 500 module into place
until its is positively seated in the card slot.
5. Use the 4 thumb screws in the module to mount the DUAL
RPA 500 front panel to the 500 series rack. These screws have a
pretty tight fit; please be careful not to cross thread.
6. Plug your 500 series rack back into the AC source and power
up your rack. Your DUAL RPA 500 will automatically power up
with your 500 series rack.
TABLE OF CONTENTS 1.0 INSTALLATION
1.0 INSTALLATION 5
2.0 INTRODUCTION 6
3.0 CONTROLS AND INDICATORS
3.1 Trim Control 6
3.2 Input Meter 6
3.3 Output Level Switch 6
3.4 -26dB Pad 7
3.5 Phase 7
3.6 75Hz High Pass Filter 7
3.7 48V Phantom Power 7
3.8 Mic Lim 8
3.9 Instrument Input 8
4.0 WARRANTY AND SERVICE
4.1 Limited Warranty 9
4.2 Service Information 10
5.0 SPECIFICATIONS 11