Amico Majestic Series Single Tier Surface Mounted Headwall - Manual (Page 3)

www.amico.com 3
Installation
1. Remove laminate panels from chase (using tool provided) by lifting panels vertically until resistance is
felt, then rotate bottom of panel out and pull down. Be careful not to drop panel.
tool provided:
suction cup
1
2
2. Place the chase at its mounting location. Refer to drawings. Mark lines where chase rear brackets are
located and where studs intersect. Mount the chase on the wall using hardware compliant to appli-
cable building codes (supplied by others). Use rear brackets to secure chase to wall (brackets to be
drilled on site). Ensure chase is secured to wall structure (studs).
3. Replace laminate panels removed in step 1 .
rear brackets