Amico Majestic Series Double Tier Recessed Headwall - Manual (Page 3)

www.amico.com 3
Installation
1. Install the console assembly into the wall opening (see Figure 3).
2. The unit should be mounted in such a way that allows for project specific drywall thickness (see Figure 5 for
reference, using a 5/8" [16 mm] drywall setup).
3. Ensure that the mounting location corresponds to the
on-site rough-in locations for medical gas and electrical
rough-ins.
4. Once the console assembly is in the correct position, attach
the console assembly to the studs using the holes on the
side and the frame provided with the unit. (see Figure
4) Use hardware that is compliant with applicable local
building codes (supplied by others).
5. The unit should be mounted in such a way that, once
drywall is installed, the frame will protrude 5/8" (16 mm)
out of the wall (see Figure 5 for reference, using a 5/8" [16
mm] drywall set up).
Figure 3
Figure 4
mounting holes
Figure 5
5/8"
[16 mm]
Support Bracket
Supplied by Amico
5/8"
[16 mm]
drywall
thickness
Building stud:
face to line up with
unit stud frame