Compaq iP-60E - Manual (Page 46)

E-
Vacuum away the dust
Please vacuum away the dust from the outside
(protruding side) of the air filter as illustrated in
the diagram.
Maintenance
1
Remove the air filter cover
Press the 2 tabs of the air filter cover down-
ward while swinging the cover outward to re-
move the air filter cover.
Air Filter Cleaning Procedure
Cleaning the Air Filter
The air filter is an important part that prevents the intrusion of dust onto the optical parts and other parts inside
the projector. When the air filter becomes blocked, the internal temperature will rise and the rotation of the fan will
also increase leading to a reduction of the service life or causing breakdown. In view of this, the air filter should be
cleaned regularly (about once a month, when the projector is used 4 hours per day).
Note that the air filter should be replaced with a new one when it becomes difficult to clean out the dust.
2
3
Install
Installation is performed by following the steps
for removal in reverse order. Press in the air
filter cover until a click sound is heard.
Air filter care and precautions
• Do not wash with water nor with hot water. Doing so will cause blockage.
• Do not wipe with a cloth or damp rag. Doing so will cause blockage.
• Always vacuum from the outside of the air filter. If you vacuum from the inside of the air filter, this will
reduce the effectiveness of the air filter.
• Do not forget to install the air filter. If the projector is left without the air filter installed, dust may enter
the projector and cause dirty projected images.
• When the air filter becomes damaged, be sure to replace it with a new one (sold separately). If the
projector is used with the air filter damaged, dust may enter the projector and cause dirty projected
images.
CAUTION
NOTE: The lamp will not light unless the air fiter cover is installed.