beautypg.com

Tamper alert, Silent arming / disarming, Arming mode selection – Clarion UNGO SYSTEM MS2005 User Manual

Page 9: Passive arming

background image

MS2005 Owner’s Manual - Page 5

* The siren chirps and light flashes during disarming will alert you if the system had been triggered while armed.

2 chirps / 2 flashes

=

normal disarming

3 chirps / 3 flashes

=

Tamper Alert - system was triggered

** If the Passenger Unlock Feature is installed, pressing Button 2 will unlock only the driver’s door. Pressing the

unlock Button 2 again unlocks all doors.

Tamper Alert

On Disarming, if the system responds with three chirps, indicating the system was triggered, the
LED will flash for 60 seconds to indicate the zone that triggered the system.

1 flash

=

door

2 flashes

=

shock sensor

3 flashes

=

trunk

example: flash-flash-pause-flash-flash-pause = shock sensor

Silent Arming / Disarming

Each Remote Transmitter can be individually set to Arm and Disarm the system with or without
chirp confirmation at the time they are programmed into the system (see Adding a New
Transmitter into the System
).

To mute the Arming and Disarming confirmation chirps, you can Arm or Disarm the system by
pressing Button 3.

Note: The confirmation chirps will only be cancelled if the system status is normal. The chirp indications for Tamper

Alert and the open zone warning will not be cancelled when the system is Armed or Disarmed silently .

Arming Mode Selection

The system can be set in one of the following Arming Modes:

• Passive (automatic) Arming with chirp confirmation
• Active Arming (by Remote Only)
• Passive (automatic) Arming without chirp confirmation

To set the Arming Mode:

1. Turn the ignition on.
2. Within 4 seconds, press the Transmitter button corresponding to desired operation.

Button 1 / 1 chirp

= Active Arming

Button 2 / 2 chirps

= Passive Arming with chirp

Button 3 / 3 chirps

= Passive Arming without chirp

Note: If no buttons are pressed for 5 seconds, Arming Mode Selection is automatically exited.

3. Turn the ignition off to save the selection.

Passive Arming

When the Arming Mode has been set for Passive Arming, the system arms itself automatically,
each time the ignition is turned off and all of the doors, hood and trunk are closed.

MS2005BO.QXD 6/27/2002 2:25 PM Page 5