Clarion UNGO SYSTEM MS2005 - Manual (Page 7)

MS2005 Owner’s Manual - Page 3
Battery Replacement
Your Ungo Remote Transmitter uses a 12 volt alkaline battery, which will need to be replaced
from time to time. Under normal conditions, the battery should last for up to a year before it
needs replacement.
When your Remote Transmitter’s battery is in need of replacement, you will notice a decrease in
your system’s operating range or a decrease in the brightness of the Transmitter’s LED indicator.
To change the battery, remove the 2 screws at the back of the Transmitter and carefully separate
the top and bottom halves of the Transmitter case.
Insert the new battery, making sure that the positive and negative terminals are positioned
correctly and replace the cover.
Adding a New Transmitter into the System
Have all desired transmitters ready (up to 3 transmitters) and follow the steps below:
1. Turn on the ignition.
2. Press and hold the Override switch.
• The status LED will turn on red.
• The siren will chirp 3 times.
3. Have all desired transmitters ready and within 5 seconds follow the steps below for each
transmitter.
For remote arming with chirp confirmation continue holding the Override switch and
press Transmitter Button 1.
--- or ---
For remote arming without chirp confirmation release the Override switch and press
Transmitter Button 1.
• The parking lights will flash once quickly to confirm that the new Remote Transmitter
has been added.
4. Wait 5 seconds then turn off the ignition.
Any transmitters that were previously learned to this system and not included in this procedure
will no longer operate this system.
Additional Remote Transmitters
Additional Remote Transmitters for your MS2005 are available from your Authorized Ungo
dealer.
MS2005BO.QXD 6/27/2002 2:25 PM Page 3