Great Plains 148-152P Assembly Instructions - Manual

© Copyright 2006 Printed
Great Plains Mfg., Inc.
Used with:
Installation Instructions
113-479M
12’ Center Pivot Hitch
Dual Marker Option
• 12’ Center Pivot Hitch
General Information
When you see this symbol, the subsequent instructions and
warnings are serious - follow without exception. Your life
and the lives of others depend on it!
!!
These instructions explain how to install the Dual Marker
Option. The 12’ Center Pivot Hitch Dual Markers are
ground marking disk units that are mounted on both sides
of the drill. These instructions apply to:
113-219A 12’ CPH Dual Marker
Manual Update
Refer to the 12’ Center Pivot Hitch Operator’s Manual for
detailed information on safely operating, adjusting, trou-
bleshooting and maintaining the Dual Marker Option.
5/5/2009
Refer to the Parts Manual for part identification.
148-152M 12’, 15’, & 20’ CPH Operator’s Manual
148-152P 12’, 15’, & 20’ CPH Parts Manual
Before You Start
Pages 5 and 6 are a detailed listing of parts included in
the Dual Marker Option. Use this list to inventory parts
received.
Tools Required
• Basic Hand Tools
Assembly Instructions
24485
Marker Assembly
Refer to Figure 1
NOTE: The RH and LH mark-
er assemblies are identical.
The multiple mounting slots
(6) in the assembly channel
allow for the marker to be at-
tached to the right or left
side of the drill with the
proper mounting brackets
(1).
Use the shear bolt (7) to de-
termine which is the left-
hand marker and which is
the right-hand marker. When
markers are installed prop-
erly, shear bolt (7) will be ori-
ented towards the front of
the hitch.
1. Attach two mounting
brackets (1) to each mark-
er mount (2). NOTE: Each
marker mounts to back-
side of coulter toolbar.
Make sure shear bolt (7) will be positioned twoards front of
hitch once markers are attached to toolbar.
2. Secure mounting brackets (1) on marker mount (2) using 3/8-
16 X 5 bolts (3), 3/8 lock washers (4), and 3/8-16 hex nuts (5).
Figure 1
Marker Mounting Brackets