Great Plains 3S-3000F Operator Manual v2 User Manual
Page 16
14
Section 1 Drill Preparation and Setup
3S-3000 Three-Section Folding Drill 195-110M-A
11/9/07
Great Plains Mfg., Inc.
Transfer Drive Shaft Front to Rear Adjustment
Figure 1-6
15620
2. Align Transfer Drive Shaft
After the wing boxes are properly aligned, the transfer
drive shaft must be aligned so the pair of break-away jaws
have full engagement and are concentric. The 7/8" hex
drive shafts holding the clutch jaws should not contact
each other when the wing boxes are properly aligned and
back against their stop. Place a 4x4 or similar sized block
ahead of the wing gauge wheels and pull forward or push
the wing box frames back until the toolbar stop bolt is firm-
ly against the stop plate on the center box frame.
To align the clutch jaws in the front to rear direction, loosen
the two 5/16" (#1) bolts which hold the 7/8" hex bearing
flangettes (#2) and slide the bearing assembly in the de-
sired direction, as shown in Figure 1-6.