Great Plains 8-10m Press Range SN 12653-12671 Operator Manual - Manual (Page 14)

8-10m Press Range
Operating Instructions
14
2. Transportation / Installation
2.3 Installation
When carrying out installation and
maintenance work there is a higher risk of
injury. It is important that you familiarise
yourself with the machine and read the
Operating Instructions beforehand.
Operator instruction and initial installation of
the machine are carried out by our service
technicians or authorised distributors.
The machine must not be used in any way
beforehand! The machine can only be
released for operation after instructions have
been provided by our service technicians or
authorised distributors.
„ If any modules or parts have been
removed for transportation, these shall
be mounted by our service technicians/
authorised dealers before the instruction
takes place.
„ Check all important screw connections!
„ Lubricate all nipples and joints!
„ Check all hydraulic connections and
lines for damage.
2. Transportation and
Installation
Transportation and initial installation of the
machine are described in this chapter.
2.1 Delivery
The machine is normally delivered fully
assembled.
„ The machine should be hitched to a
tractor and driven off a low-loader.
2.2 Transportation
The Press can be transported on public roads
by hitching it up to a tractor or on a low-loader.
„ It is important to observe the permitted
dimensions and weights when
transporting the machine.
„ If the machine is transported on a trailer
or a low-loader, it must be secured
using straps or other devices.
„ Before transporting the machine on
public roads, it must be adjusted to its
transportation position and the
stipulations relating to road
transportation fulfilled.
„ The maximum permissible speed is 25
km /h.