Great Plains 2N-3020 Assembly Instructions - Manual (Page 4)

Figure 1
Attaching Fourth Section 11103
4 24- and 30-Foot, No-Till Flat Fold Marker Option 113-502M 4/9/04
Great Plains Mfg., Inc.
Assembly Instructions
■
Refer to Figure 1.
12. Mount the transport carrier (45) to the box frame on the in-
side of the gauge-wheel mount. Use the mounting bracket
(52) and secure it with the four 1/2 x 9 1/2-inch bolts (53), the
plate (54), lock washers (55) and nuts (56).
NOTE: On 30-foot drills, you may need to reposition the optional
weight brackets to make room for the transport carrier.
13. Fasten the carrier to the mount using the two u-bolts
(47).Tighten the u-bolts with the lock washers (48) and nuts
(49) so that the top of the carrier is about 29 3/8 inches
above the top of the frame tube. You may need to re-adjust
carrier height after assembly. Refer to Transport Carrier,
"Setup Adjustments," page 7.
14. Mount the transport saddle (50) on the top of the carrier arm
(45) using the u-bolts (51), lock washers (48) and nuts (49).
On 24-foot drills, position the offset in the saddle to the out-
side of the drill as shown.
15. To complete assembly for dual markers, repeat steps three
through nine.
Figure 1
Transport Carrier Mounting
11701
16. After all parts are in place, tighten all bolts and u-bolts. Refer
to the torque chart in your drill operator’s manual. Torque u-
bolts to grade 5 values.