Great Plains UT5052 Operator Manual - Manual (Page 19)

Great Plains Manufacturing, Inc. Preparation and Setup 15
12/31/2013 576-026M-A
Side to Side Leveling
Refer to Figure 7
7. The initial side to side leveling is best be done before
modules are installed.
8. On level surface, unfold and lower the machine until the
cylinders are completely retracted and measure down
from the ground. Take note of the measurements
9. Repeat the same procedure at each section to pre-
level the machine by adjusting the eyebolt
on each
cylinder until each wing section is the same as the cen-
ter section.
Figure 7
Wing Depth Adjustment
43185
1
1