Great Plains Simba Single Press Operator Manual - Manual (Page 15)

15 Simba Single Press
609-060M-ENG
2013-01-25
2.3 Installation
When carrying out installation and
maintenance work there is a higher risk
of injury. It is important that you familiarise
yourself with the machine and read the
Operating Instructions beforehand.
Operator instruction and initial installation of
the machine are carried out by our service
technicians or authorised distributors.
The machine must not be used in any way
beforehand! The machine can only be
released for operation after instructions have
been provided by our service technicians or
authorised distributors.
• If any modules or parts have been
removed for transportation, these shall
be mounted by our service technicians/
authorised dealers before the instruction
takes place.
• Check all important screw connections!
• Lubricate all nipples and joints!
• Check all hydraulic connections and lines
for damage.
2. Transportation and
Installation
Transportation and initial installation of the
machine are described in this chapter.
2.1 Delivery
The machine is normally delivered fully
assembled.
• The machine can be lifted off with a crane
or other suitable lifting equipment.
• The machine should be hitched to a
tractor and driven off a low-loader.
2.2 Transportation
The Simba Single Press can be transported
on public roads by hitching it up to a tractor
or on a low-loader.
• It is important to observe the permitted
dimensions and weights when
transporting the machine.
• If the machine is transported on a trailer
or a low-loader, it must be secured using
straps or other devices.
• Before transporting the machine on
public roads, it must be adjusted to
its transportation position and the
stipulations relating to road transportation
fulfilled.
• The maximum permissible speed is 25
km/h.
2. Transportation / Installation