Great Plains P15843 Serial No 18007975 - Manual (Page 23)

23 X-Press
Operating Instructions
4.7 Starting Settings
This page details the recommended starting settings for the X-Press. These settings can
then be used as a base for further adjustment in order to get the optimum performance from
your machine.
4. Adjustment / Operation
Disc Angle Adjustment Jacks
Front Gang Rear Gang
3 Point Linkage / DD Light Roller
The machine should be set to run level front to rear and left to right.
4.6.1 Variation of Settings
If working conditions change (for example, from dry to wet conditions) then the following table
should be consulted as a rough guide.
VARIATION IN CONDITION SETTING REVISION
REDUCE DISC ANGLE
REDUCE CHASSIS PITCH
INCREASE DISC ANGLE
REDUCE SPEED
INCREASE CHASSIS PITCH
MOVE PINS ON ROLL LINKAGE
REDUCE SPEED
INCREASE DISC ANGLE
FROM HARD/DRY TO LOOSE/WET
FROM STUBBLES TO HIGHER TRASH
(TO INCREASE INCORPORATION)
FROM SHALLOW TO DEEP (NOTE 75-
100mm MAX WORKING DEPTH)
Д
Д
Д Д
SHALLOWEST
SETTING