Great Plains TC5319 Predelivery Manual - Manual (Page 19)

Great Plains Manufacturing, Inc. Table of Contents Index Assembly 15
04/12/2012 Table of Contents Index 566-046Q
5113-5115 Wings
Refer to Figure 17
66. Attach wings
with 3/4 x 2 1/2 hex bolts 3/4 lock
washers and 3/4 nuts.
67. Tighten all u-bolts to specs, See “Torque Values
Chart” on page 17.
Note: Folding models will be shipped with wings attached.
Light Brackets
Note: Model 5109 light brackets will be installed in the
proper location but turned towards inside of ma-
chine. See machine layout in Appendix for proper lo-
cation.
Refer to Figure 18
68. Remove 1/2 x 4 1/32 x 7 1/4 u-bolts
from light
bracket assembly . Rotate light bracket assembly
180 degrees. Re-install 1/2 x 4 1/32 x 7 1/4 u-bolts ,
secure with 1/2 lock washers and 1/2 nuts.
69. Tighten all u-bolts to specs, See “Torque Values
Chart” on page 17.
70. Attach light plug to light wiring harness that is
pre-assembled to frame.
Figure 17
5113-5115 Wings
42643
1
2
1 2
Figure 18
Light Brackets
42644
1
3
2
4
2
1 1
2
3 4