Great Plains Simba UniPress Operator Manual - Manual (Page 37)

37 Simba UniPress
607-114M-ENG
2013-01-25
6. Faults and Remedies
6. Faults and Remedies
Simba UniPress Troubleshooting
Fault
Possible Cause Remedy
Roll axle starts to block
regularly.
Machine running too tail
low.
Lengthen work drawbar
cylinder until chassis is
horizontal or just tail low.
Increase quantity of shims
in depth stop unit.
Roll axle is not tight. Tighten axle.
Ground conditions too wet. Wait for more suitable
ground conditions.
Roll scrapers incorrectly
adjusted.
Set scrapers to run just
clear of rings and centrally
between each ring.