Great Plains 3N-3020 Assembly Instructions - Manual (Page 7)

4/8/2004 120-301M
Great Plains Mfg., Inc.
7 Installation Instructions
Refer to Figure 12
17. Connect sensor cable to short leads on sen-
sor module. Either cable can be connected to
either lead.
18. Uncoil hydraulic hoses and main harness and
tie ends together. Feed a fish tape or a wire
from the front of the tongue and pull the hoses
and cable through the main tongue and route
through the hose carrier on front of the
tongue.
19. Install the plastic hose label, P/N 817-348C,
to hose with “extension” symbol on the hose
running to filter (marked P) on control module.
Use the yellow cable tie to identify this as a
motor hose. Attach motor return hose
(marked T) on the side showing the “retract”
symbol. Run tie strap through number that will
correspond to the valve 2 through 4 that the
drive will be connected to.
Refer to Figure 13
20. Install the console in a convenient location on
a side window glass. Make sure the glass is
clean. Moisten cups and press firmly onto the
glass. To remove, pull tab on suction cup.
21. Connect power port adaptor cable to the ter-
minal on the console.
22. Route the power and communication cables
through the cab access hole and connect to
the appropriate terminals on the console.
Sensor Module
Communication
Cable
Power Port
Adapter
Serial Cable
(for recipe input)
Figure 13
Control Console
19977
Console
Figure 12
Sensor Module
20043