Great Plains 3N-3020 Assembly Instructions - Manual (Page 3)

4/8/2004 120-301M
Great Plains Mfg., Inc.
3 Installation Instructions
Refer to Figure 4
4. To mark and drill mounting holes for the con-
troller/motor kit, use the dimensions supplied
on page 8. Mark the holes on the left-hand
tongue gusset on the mainframe and carefully
drill all four holes.
Note: It is important that you carefully mark and
drill these mounting holes. The lower portion of
the drive mount houses the carrier bearing for the
pivot shaft. Misalignment will cause operational
problems.
Refer to Figure 5
5. Drill holes with either a 17/32” or 9/16” drill bit.
Place Template
Here
17/32”
Holes
Figure 4
Hole Chart
Figure 5
Left-hand Gusset
20036
20198