Clarion DSH920S - Manual (Page 10)

10
DSH920S
English 5. INSTALLATION AND WIRE CONNECTION
Before Installation
1. Before starting, be sure to disconnect the
battery’s negative “–” terminal to prevent ac-
cidents due to short-circuits.
2. Location
Consider safety and operability when select-
ing a place for installation. Avoid the follow-
ing.
• Locations where the unit will hamper driving.
• Locations where the unit could injure passen-
gers if the car stops suddenly.
• Locations exposed to direct sunlight or hot air
from the heater, etc.
• Locations where the unit may be exposed to
rain or water.
3. Be sure to use the included screws and
brackets. Screws other than those supplied
could damage the unit.
4. When drilling holes in the dashboard, etc., be
sure to check beforehand that there are no
harnesses or other wires inside.
Case Case
8mm max.
Damage
Accessories
1 Mounting bracket .............................. 2 pieces
2 Mounting screw ................................ 4 pieces
3 Canoe clip ......................................... 4 pieces
4 CeNET cable ...................................... 1 piece