Great Plains 2SNG30 Operator Manual - Manual (Page 28)

2SNG24 & 2SNG30
202-499m 8/17/2006
26
Transporting
!
CAUTION
This drill should never be pulled faster than 20 miles
per hour!
Before transporting drill:
1. Make sure that hitch is securely attached to
the draw bar of the tractor and that the hitch
safety chain has been securely fastened.
Refer to Figure 19
2. To prevent possible damage in case of hy-
draulic failure during transport. Always insert
transport lock pins when transporting.
Refer to Figure 20
3. Check to be sure the pull-bar transport lock
pin is in the transport position.
4. Check to see if you have the required air pres-
sure in your transport tires. For proper infla-
tion see “Tire Inflation Chart," page 36.
5. When in transport, use warning lights and
safety hitch chain. Comply with all federal,
state and local laws when traveling on public
roads.
6. Be sure that the drill is properly folded. The
drill boxes must be correctly supported in the
folded position. See "Folding," page 24.
7. Reduce speed of the tractor when transport-
ing over uneven or rough terrain. Avoid all
chuck holes and washboard areas in roads.
8. Reduce speed of the tractor when transport-
ing over hills or steep slopes. Never exceed
20 miles per hour.
9. Use "Slow Moving Vehicle" emblem
for warning vehicles approaching from the
rear.
10. When transporting, remember the drill is wid-
er than your tractor and extreme care must be
taken to allow for safe clearance.
11. Extra care should be taken when transporting
with seed in the box.
17269
10739
Figure 19
Transport Lock Pin in Transport Position
Figure 20
Pull-Bar Lock Pin in Transport Position