Great Plains 4336 DH Parts Manual - Manual (Page 35)

Revision Comments Part Description Part No. Ref.
Image No. dwg41265
WALKING BEAM SPINDLE 556-098H 1.
WALKING BEAM RH 556-192H 2.
WALKING BEAM LH 556-193H 2.
SEAL 2.50IDX3.251DX.47T 816-573C 3.
BRG CONE 1.97ID JLM104948 822-226C 4.
BRG CUP JLM104910 822-225C 5.
PIVOT SPINDLE SLEEVE 556-287D 6.
WASHER MACH 2.25 X 1.50 X 10GA 804-063C 7.
NUT HEX SLOTTED 1 1/2-12 PLT 803-239C 8.
PIN COTTER 1/4 X 3 PLT 805-115C 9.
(S/N A1260P+) See hub & spindle
pages for parts.
HUB 8-BOLT SPNL 2.25X13.25 458 815-277C 10.
HHCS 5/16-18X4 GR8 PLT 802-802C 11.
NUT HEX TOP LOCK 5/16-18 PLT 803-166C 12.
WALKING BEAM STOP 556-302D 13.
HHCS 3/4-10X3 GR5 802-383C 14.
WASHER LOCK SPRING 3/4 PLT 804-023C 15.
NUT HEX 3/4-10 PLT 803-027C 16.
WHEEL 15X8 8 BOLT WHITE 814-222C 17.
TIRE 11LX15 LOAD F 814-226C 18.
TIRE/WHL 11LX15 LOAD F 8BLT WH 814-235C 19.
NUT LUG 9/16-18 X 90 PLT 803-061C 20.
GREASE ZERK 1/4-28 THD FORMING 800-080C 21.
05/21/12 - 35 - 556-100P
Table of Contents Part Number Index
Section 3: Transport
Center Walking Beam; 3329 (S/N A1260P+)
(Applies to 3329DH only)