Wheatheart GHR Auger Wheel Kit - Manual (Page 5)

W HEATHEART - W HEEL K IT 1. S AFETY
BH/GHR A UGERS 1.1. S AFETY D ECAL L OCATIONS
30736 R1 5
1. Safety
Refer to your auger manual for complete safety instructions.
1.1. SAFETY DECAL LOCATIONS
• Keep safety decals clean and legible at all times.
• Replace safety decals that are missing or have become illegible. See decal
location figures that follow.
• Replaced parts must display the same decal(s) as the original part.
• Safety decals are available from your distributor, dealer, or factory.
1.1.1. D
ECAL
I
NSTALLATION
/R
EPLACEMENT
1. Decal area must be clean and dry, with a temperature above 50°F (10°C).
Use a solvent to remove all traces of oil from manufacturing before applying
decal.
2. Decide on the exact position before you remove the backing paper.
3. Align
the decal over the specified area and carefully press the small portion
with the exposed sticky backing in place.
4. Slowly peel back the remaining paper and carefully smooth the remaining
portion of the decal in place.
5. Small air pockets can be pierced with a pin and smoothed out using the sign
backing paper.
1.1.2. D
ECAL
L
OCATIONS
Replicas of the safety decals that are attached to the equipment are shown in the
figure(s) that follow. Proper safety procedures require that you familiarize
yourself with the various safety decals and the areas or particular functions that
the decals apply to as well as the safety precautions that must be taken to avoid
serious injury, death, or equipment damage.