Casablanca Fan Company Marrakesh 89UXXM - Manual (Page 3)

3
M
arrakesh
™
INSTALLATION INSTRUCTIONS
Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping
cartons and check them against the parts listed in instructions.
Before discarding packaging material, be certain that all parts have been removed.
gETTINg STARTED
Carton Contents
The fan carton contains the fan body, warranty card, owner’s
manual, and all the parts necessary to assemble and install
your Casablanca ceiling fan. These parts are shown at the
start of each installation section. Before you start, go through
this Owner’s Manual and confirm that you have all the parts
shown in each section.
gETTINg STARTED - CONTINUED
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish
to place your Casablanca fan, an approved ceiling fixture
outlet box must be installed and wired.
Warning: To reduce the risk of fire, electrical shock, or
personal injury, mount to outlet box marked acceptable
for ceiling fan support.
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit breaker
or fuse box), lower the old fixture and disconnect the wiring.
Check the ceiling fixture outlet box to be sure that it is a UL
listed ceiling box for ceiling fan applications. If it is not, a
new box must be installed.
Be sure to use only genuine Casablanca blades. The blade
shrink wrap holds 3 blades of matched weight. If more than
one fan is being installed, be sure not to mix blade sets.
CAUTION: When removing the shrink wrap, be careful not
to scratch the blades.
CANOPY HARDWARE
CANOPY
CANOPY LOCK WASHER
#8 (4)
CANOPY SCREW
8-32 X 4 1 / 8 ”
(4)
CEILINg HARDWARE
CROSSBAR mOUNT-
INg BRACKET
WIRE NUT (4)
addiTional hardware
2 1 / 4
” x 8-32 ROUNDED
HEAD SCREW (2)
FLAT WASHER (2)
1” x 8-32 ROUNDED
HEAD SCREW (2)
SUPPORT INSTALLATION PARTS
lag screw
3 /
8
” #7 X 5” (1)
large
flaT washer
3 /
8
” (1)
CANOPY
HATCH