Dymo S50 - Manual (Page 8)

4
Using the Hold Feature
When an item being weighed extends over the front of the scale and you cannot see the
display, you can freeze the display so that the weight is still displayed after removing the item.
To use the Hold feature
1. Press .
The display shows HOLD and then 0.0 when ready.
2. Place the item on the scale.
3. After a few seconds, remove the item from the scale.
The weight continues to be displayed for about ten seconds.
4. Press to deactivate the hold feature.
Changing the Units of Measure
Your scale can display weight in English (pounds) or metric (kilograms) units. The default unit
of measure is metric. Each time you turn on the scale, the scale defaults to the unit of measure
that was last used.
To change the units of measure

Press to toggle between English and metric units.
Mounting the Display
The scale features a detachable display. The display can be mounted to most metallic surfaces
using the built-in magnets. You can also mount the display using the mounting holes on the
back of the display and standard screws. A mounting template is included at the back of this
User Guide. The display can be mounted up to 1.8 meters (6 feet) from the scale base.
To mount the display to a non-metallic surface
1. Drill two holes 120 mm (4 3/4 inch) apart at the desired height on the wall using the
template at the back of this User Guide.
2. Screw one screw into each of the holes until the screw head sticks out from the
wall 3 mm (1/8 inch).
Allowing the screw heads to stick out farther than 3 mm (1/8 inch) may damage the
scale display.
3. Align the holes on the back of the scale display with the screws.
4. Slide the display onto the screws.
The display should slide onto the screws firmly and securely.
HOLD
HOLD
kg lb
!