Dymo S50 - Manual (Page 10)

6
Troubleshooting
If you need further assistance, you can obtain support at www.dymo.com.
Warranty
TWO-YEAR LIMITED WARRANTY
Dymo scales are sold with a two-year warranty from the date of purchase against defects in design, materials and
workmanship. If this product is found to be defective within that time, we will promptly repair or replace it at our cost.
This warranty does not cover accidental damage, wear and tear or consequential or incidental loss.
WHAT IS COVERED?
This warranty covers this product only and only against defects in design, materials or workmanship. If, after inspection of
your returned product, we find that the product is defective in design, materials or workmanship, we shall at no charge to
you repair or replace the product at our discretion, and return the product to you. You are responsible for the full cost of
shipping the product to Dymo, but there is no charge for the inspection or the return postage.
WHAT IS NOT COVERED?
This warranty does not cover loss of or damage to a computer or other devices connected directly or indirectly to this
Dymo product. This warranty also does not cover any loss of or damage to data, programs, records or other information.
This warranty does not cover any defect or loss which would not have occurred if instructions in the owner's manual had
been followed. This warranty does not cover other incidental or consequential damages even if Dymo has been informed
of the possibility of such damages. This warranty is in lieu of all other warranties, express or implied. This warranty gives
you specific rights and you may also have other rights, which may vary from state to state or country to country.
HOW TO MAKE A WARRANTY CLAIM
To make a warranty claim, please contact customer support: www.dymoservice.com
Electrostatic Discharge Precautions
Electrostatic discharge (Static Electricity or ESD) can cause damage to any electronic device, including the scale. To avoid
damage, follow these simple steps:
•
Always disconnect the scale from your computer or USB hub when changing the battery.
• Always discharge any accumulated static electricity from yourself before connecting the scale to your computer or
USB hub. If your computer uses a three-pin, grounded connector, you can do this by touching the metal case of your
computer. As an alternative, try touching a cold water faucet.
Problem/Error Message Solution
No display Ensure the scale is plugged in, or replace the batteries.
LO is displayed Replace the batteries.
Negative number is displayed A tare value is displayed as a negative number when the items
are removed from the scale. Press
to reset the scale to zero.
00000 is displayed The item on the scale platform exceeds the maximum capacity
of the scale. Remove the item immediately to prevent damage
to the scale.
Display reads 0.0 with an item on the
platform This can happen because:
• The Tare/Zero button,
, was pressed while an item was on
the scale.
• Power to the scale was disconnected or turned off and then
on again with an item on the scale.
In both of these cases, remove the item from the platform and
press
to return the display to 0.0.
0.0
TARE
0.0
TARE
0.0
TARE