ClearOne Wood Plasma Cart - Manual (Page 8)

6 Furniture Service Department: 800.283.5936
WOOD DUAL PLASMA CART
ASSEMBLING THE HARDWARE
1. Align the Vertical Support over the pre-drilled holes in the Universal Base.
2. Secure the Vertical Support by inserting six 5/16 1 ½” Bolts through the top of
the Vertical Support and the top of the Universal Base. Secure the bolts using six
flat washers and six 5/16 nuts underneath the top of the Universal Base.
3. Line up the Horizontal Support alignment pins with the guiding holes on the Vertical
Support at desired height and slide into place.
4. Hold the Horizontal Support in place while securing it to the Vertical Support using six
5/16 ¾” Bolts.
»
NOTE: The Horizontal Support can be raised or lowered on the Vertical Support to
achieve the desired viewing position of the plasma screens.
FIGURE 2.6 Vertical Support Installation
FIGURE 2.7 Horizontal Support Installation