Casio WK210ES1A - Manual (Page 13)

English
Playing the Digital Keyboard
E-11
You can use the voice pads to sound various sound effects or
even sounds you have sampled (page E-19). Use the voice
pads to add something extra to your performances.
1.
Press bq .
2.
Press cs and ct at the same time to enable the
voice pads.
• Pressing cs and ct at the same time again will disable
the voice pads.
• Be sure to make sure the voice pad function is enabled
before performing the next step. While voice pads are
disabled, buttons
bt through co function as
registration memory buttons (page E-48). Performing
the following step with voice pads disabled will change
the setup of the keyboard (tone number, rhythm
number, etc.).
3.
Press a voice pad (1 through 5, ck through co )
to sound what is assigned to it.
There are four sets of voice pad sounds numbered
1 through 4 (see below). Each press of
bt cycles through
sound sets 1 through 4.
Example: When Set 2 is selected
• While a sound set number is displayed, you can change it
using bs (10-key). If you do not perform any operation for a
few seconds after the indicator appears, the display will
return to the previous screen automatically.
Using the Voice Pads
Lit when on
Pad 1 Pad 2 Pad 3 Pad 4 Pad 5
Set 1
VOICE 1
(Tone 571) *1
VOICE 2
(Tone 572) *1
VOICE 3
(Tone 573) *1
VOICE 4
(Tone 574) *1
VOICE 5
(Tone 575) *1
Set 2 Set 1 at various pitches *2
Set 3 Same as Set 1 Set 1 sound, repeated *3
Set 4 APPLAUSE GUNSHOT BONGO CONGA TAMBOURINE
*1: If you performed melody sampling (page E-20) and
assigned the results to these tone numbers, the pad will
output the sampled sound.
*2: Pad 1: Perfect fifth up; Pad 2: Perfect fifth down;
Pad 3: Same as Set 1; Pad 4: Starting from a major third
down, gradually raises the pitch; Pad 5: Starting from one
octave up, gradually lowers the pitch
*3: Pad 3 gradually raises the pitch
bt ck cl cm cn co
P a d S e t