Cobra Electronics Mrf 80b - Manual (Page 58)

Operating Your Radio
Nothing Comes Close to a Cobra ®
Advanced Operation
55
Memory Channels
Program or select an unlimited number of channels for the
Memory Scan mode.
To Program Memory Channels:
1. From Standby mode, select a channel to record using the
Channel Up/Down buttons.
2. Press and hold the Memory Scan/Memory Clear button
for three (3) seconds. The channel is recorded for
scanning and MEM (memory channel) appears on the
LCD when that channel is selected.
3. Press the Memory Scan/Memory Clear button to begin
scanning.
The radio returns to Standby mode when the Memory
Scan/Memory Clear button is pressed again.
4. Repeat steps 1 through 2 to record additional channels.
To Clear Memory Channels:
Repeat the steps above in the “To Program Memory
Channels” section, this time holding the Memory
Scan/Memory Clear button down for three (3) seconds to
clear the memory from the selected channel. Repeat as
necessary to clear additional channels.
Memory Channel
Memory Channel
Memory Scan/
Clear Button
8187-F80-Operation-8_MMB:F75-Operation-8 12/29/06 9:03 AM Page 55