CLIFFORD 50 - Manual (Page 13)

TO SILENTLY
ARM OR DISARM
THE SYSTEM . . . . . . . Press button 3 (channel 3). Your Concept 50 system will arm or
disarm with all the indications noted on the previous page except
for the chirp acknowledgments.
TO REMOTELY
TURN ON THE
HEADLIGHTS
— OR —
REMOTELY CLOSE
THE WINDOWS
WHILE THE SYSTEM
IS ARMED . . . . . . . . . Button 2 (channel 2) controls an interlock that allows you to
separately command two different options with the same channel:
one when the system is armed and another when it is disarmed.
For instance, if your Concept 50 was so wired, pressing button 2
while the alarm is armed will either turn on the head- lights for
any duration you wish between 1 second and 2.5 minutes (see the
Headlight Timer feature in User-selectable features on pages
19–21) OR will fully close all the power windows and sunroof on
various Jaguar, Mercedes Benz, BMW and Volkswagen vehicles.
TO REMOTELY
OPEN THE TRUNK . . . As noted above, button 2 (channel 2) can control yet another
option when the system is disarmed. The most obvious one is the
remote trunk release. If you have this option installed, pressing
button 2 while the alarm is disarmed will remotely open the trunk.
TO ACTIVATE
OTHER OPTIONS
REGARDLESS OF
ALARM STATE . . . . . . . Button 4 (channel 4) and channels 5–8 and 11–12 (see How to
use your keychain remote control on page 9) can activate other
accessories such as the Clifford IntelliStart remote engine starter,
remote memory seat activation, SmartWindows II remote
window roll-down and venting, a Programmable Receiver that
lets you command your electric garage door/gate opener(s), etc.
What about
channels 9 & 10? . . . Channels 9 and 10 control the Remote QuickAccess™ features:
remote valet mode entry/exit and remote long-term chirp
silencing/restoration. See Remote QuickAccess on page 16.
How to interpret the chirps and parking light flashes
When you use the remote control, the system responds with chirps (unless the chirp muting
feature is turned on) and parking light flashes. These chirp/flash acknowledgments mean:
Chirps and flashes Meaning
1 Your Concept system is disarmed
2 Your Concept system is armed
2 and then 4
Armed but there is a door open (if there was a 5-sec. delay) or one of the sensors is
malfunctioning (if there was a 10-sec. delay) (see Smart AutoTesting)
3 Disarmed and there was an intrusion attempt (see Smart Prior Intrusion Attempt)
4 Armed and there is a trigger malfunction (see Smart AutoTesting)
5 20-seconds to engine shutdown: enter your disarming code IMMEDIATELY
11