beautypg.com

The mono input channels – Crate Amplifiers PM82S User Manual

Page 4

background image

1. PEAK LED: This LED illuminates when the input signal

nears clipping. During normal operation, this LED will flash
on strong signal peaks. If the LED remains illuminated,
depress the Pad switch (#9) and/or reduce the level of the
signal connected to the input jack (#10,11).

2. HIGH: Use this control to adjust the high frequency level

for the channel.

3. MID: Use this control to adjust the midrange frequency

level for the channel.

4. LOW: Use this control to adjust the low frequency level for

the channel.

5. MON: Use this control to adjust the amount of the chan-

nel’s signal sent to the monitors.

6. EFFECT: Use this control to adjust the amplitude of the

internal DSP effect (or external effects, if used) to be
applied to the channel’s signal.

7. PAN: Use this control to adjust the left-to-right balance of

the channel’s signal.

8. LEVEL: Use this control to adjust the channel’s output sig-

nal level.

9. PAD: Use this switch to accommodate “hot” input signals.

(Signals too strong to allow a useful setting of the gain con-
trol without causing the Peak LED - #1- to remain illuminat-
ed.) Depress this switch to engage the 20dB pad, thereby
reducing the input signal’s level to a more useable range.

10. HIGH-Z LINE: Use this jack to connect the output signal

from a high impedance microphone or a line level signal
(such as an instrument, rhythm machine, tape deck, etc.)
to the mixer by means of a shielded cable terminated with
a male 1/4” plug. Tip = “+,” ring = “–,” sleeve = shield.

11. MIC: Use this jack to connect the output signal from a low

impedance microphone to the mixer by means of a shield-
ed cable terminated with a male XLR plug. Pin 2 = “+,” pin
3 = “–,” pin 1 = shield.

The Mono Input Channels:

1

2

3

4

5

6

7

8

9

10

11

4

PM62S/PM82S/PM82T Powered Mixers

This manual is related to the following products: