Winchester Repeating Arms Wildcat - Manual (Page 16)

the barrel at the receiver end and run it back and
forth several times. NOTE: Use a crown protector if
you are cleaning from the muzzle end of the barrel.
Damage to the crown of a barrel can affect the accuracy
of your rifle.
3. Inspect the chamber and bore for powder fouling.
A normal amount of powder residue can be expected
and is not serious. It can usually be removed by
repeating step 2, using a patch saturated with solvent.
If, or when, fouling should become heavy, it can be
removed with a brass bore brush. Dip or spray the brush
with solvent and scrub the chamber and bore until the
fouling is removed. To prevent brass bristles from
breaking off, the brush should be pushed completely
through the bore before being withdrawn.
4. After fouling has been removed the bore should
be wiped dry. Then pass a lightly oiled patch
through the bore for preservation. A fine, light gun
oil is recommended.
5. Wipe all exposed metal surfaces of the receiver, forearm
and barrel with a clean rag. Finger marks should be
removed because they provide a place where moisture
can accumulate. Any dried oil in the receiver area
should also be removed.
6. Lightly oil the bolt guide lugs and guide rails. Ordinary
good judgment will, of course, indicate that the metal
of the gun should receive a light film of oil any time the
rifle has been exposed to weather or handling. This is
very important and must be done with every firearm.
Remember, the fitted surfaces of the receiver and
action mechanisms must always have a thin film of
oil. Make sure that the surfaces of the breech bolt are
especially clean and lightly oiled with a high quality
gun oil. Do not use pure silicone or lanolin.
7. Inspect the barrel and chamber. Make certain that no
patches have been inadvertently left in them. Remove
any that remain.
8. Wipe all wood surfaces with a lightly oiled cloth.
9. When transporting your rifle, store it in a quality
protective case to prevent scratches and dents. Store
your rifle in a dry place to prevent corrosion. Store your
rifle and ammunition separately, away from children.
MAKE SURE YOUR RIFLE IS UNLOADED AND ALWAYS
STORE AMMUNITION SEPARATELY.
O THER C LEANING S UGGESTIONS —
• Never pour large quantities of oil into the receiver or
other parts of your rifle. It can drain down into the
wood and soften it, causing permanent damage and
loosening of the stock.
• After extended periods of heavy use, your gun should
be taken to a qualified gunsmith to have the action
disassembled for professional cleaning and lubrication.
15
05-572-WFA_OM Wildcat 6 3/21/06 11:28 AM Page 15