Wildview STC-TGL-5M - Manual (Page 14)

Wildview Series
www.wildviewcam.com Toll Free 888-304-6125
14
c. Time and HH will blink. Press [UP] or [DN] to adjust the hour.
d. Press [SET] button to enter minute setting. Time and MM will
blink. Press [UP] or [DN] to adjust the minute.
e. Press [SET] button to enter the month setting. Date & MM will
blink. Press [UP] or [DN] to adjust month.
f. Press [SET] button to enter date setting. Date & DD will blink.
Press [UP] or [DN] to adjust date.
g. Press [SET] button to enter year setting. Date & YY will blink.
Press [UP] or [DN] to adjust year.
h. Press and hold [SET] button for 2 seconds to exit the setting
mode and enter into PIR count down mode. Display will show
date and number of pictures taken.
Once the program setting has been completed, slide the power
switch to OFF position until you are ready for field use.
NOTE: Date & Time setting will be lost whenever the batteries are
removed from camera. Remember to re-set the Date & Time
stamp after you replace the batteries.