Wildview STC-TGL-5M - Manual (Page 13)

Wildview Series
www.wildviewcam.com Toll Free 888-304-6125
13
Programming your Wildview Camera
The following setting must be performed before you turn on the
camera.
1. Select the time out interval by sliding the time out toggle switch to
the desired preset time interval in minutes. 1 / 5 / 10 / 20 minutes.
2. Select the resolution setting by sliding the resolution toggle switch
to the desired resolution setting. Hi / Lo resolution.
3. Select the Flash mode: Slide the switch to either Auto / On / Off
position.
a. Auto
– Flash based on surround light conditions.
b. On
– Turns the flash on.
c. Off
– Turns off the flash.
4. Select capture mode: Slide the switch to 1 / 3 / 6 / AVI position. If
you choose AVI mode, the camera will automatically switch to 1 still
picture mode if it detects a low light source.
5. Turn on the Camera to set the Date / Time stamp:
a. Slide the power switch to the PIR position.
b. Press and hold [SET] button for 2 seconds to enter date & time
setting mode.