Waring WFP14SW - Manual (Page 5)

8 9
ASSEMBLY OF BATCH BOWL PARTS
WFP11SW & WFP14SW
We will use the terms bowl, work bowl, batch bowl and cutter
bowl interchangeably throughout this instruction book. They
mean the same thing.
• Clean and sanitize the motor base, and wash, rinse, and
sanitize the bowl, cover, food pusher, food pusher insert and
processing tools prior to initial use.
• Place the base on a counter or table near a 3-prong electrical
outlet. Position it so you look at the front of the unit and can
see the control levers. Be certain that the cord is unplugged
and the OFF lever has been pressed. Do not plug in the cord
until the processor is completely assembled.
• Pick up the transparent work bowl, holding it in both hands
with the handle toward you.
• Place the bowl on the base, fitting its central tube over the
motor shaft on the base and placing its handle slightly to the
left of front-center (at about a 7-o’clock position).
• Press the bowl down so the lower rim fits around the circular
platform. Turn the bowl counterclockwise as far as it will go. It
will lock into position with the tabs on the sides of the platform.
• Pick up the metal blade, noting the diagram on the top of
plastic center. It matches the shape of the motor shaft.
• Place the S-blade over the tip of the motor shaft, lining up the
inside of the hub with the shaft.
• Press it down firmly, rotating the center hub until the blade
assembly is fully seated. It should easily drop into place. Push
firmly to lock the sealed S-blade hub in place. Be sure it is
pushed down as far as it will go. If it is not all the way down, it
may become damaged and any liquid may leak. Push only on
the center section (plastic part); never touch the cutting blade
as it is extremely sharp.
• Check to be sure the blade is all the way down by turning
it back and forth while lightly pushing it down. If properly
installed and fully seated, the lower blade will be positioned
just above the inside bottom of the bowl.
• If processing food with the S-blade, now is the time to add the
food or liquid to the work bowl.
• Always process dry food first, then add wet food.
• Do not fill liquid over MAx LIQUID FILL line.
• Place the cover on the bowl, with the feed tube on the left,
slightly toward the front. The locking tabs on the cover should
be at the left of the locking tabs on the rim of the work bowl.
• Rotate the cover counterclockwise to lock it into place. When
the cover is rotated into place, the safety interlock tab on the
back rim of the cover will activate the interlock mechanism and
your food processor is ready to operate.
• NOTE: The cover must be in place correctly, with the cover’s
safety interlock tab firmly engaged, for the food processor to
operate. This is an important safety feature.
NEVER ATTEMPT TO START THE FOOD PROCESSOR
WITHOUT THE COVER LOCKED INTO POSITION.
DISASSEMBLY OF BATCH BOWL PARTS
WFP11SW & WFP14SW
ALWAYS UNPLUG THE CORD BEFORE DISASSEMBLING.
• Turn the bowl cover clockwise until the safety interlock tab on
the cover is disengaged.
• Remove the work bowl from the unit by rotating clockwise to
disengage the tabs on the bottom of the bowl platform from
the work bowl. When the bowl handle is on the left (about 7
o’clock), you can gently lift the bowl straight up and out.
It is recommended that you remove the bowl from the motor base
before you remove the S-blade.
• To remove the blade, it is recommended that you remove any
product from the batch bowl first by pouring it out. Note the
blade will stay locked in place while pouring out the product.
Once the bowl is empty, pull the sealed S-blade or whipping
disc out by holding on with a firm grip while pulling out. Once
you hear a click, the S-blade or whipping disc should come
out with ease.