Waring MX1500XTXP - Manual (Page 5)

5
8. Allow motor to come to a complete stop before removing container from
blender base. Never place the container on the motor base or remove it
from the motor base while motor is running.
9. Wash and dry container after each use. See Cleaning and Sanitizing
Instructions.
10. To turn the unit off, press STANDBY button. Green LED light will
go off.
MX VARIABLE SPEED OPERATION
warning – This is a Class A product. In a domestic environment this
product may cause radio interference, in which case the user may be
required to take adequate measures.
1. Before starting, make sure that the blender is
unplugged and container is not positioned on
the blender.
2. Put ingredients into container and cover it.
Do not fill above MAX line.
3. With the unit in STANDBY I position, place
container on blender base. Be sure
container is fully seated and that drive
coupling is properly engaged. Plug blender
cord into outlet.
4. This blender has variable speed controls. Set blender to desired speed
between 1 and 10.
5. The left paddle switch defaults to the VARIABLE setting in order to use
the speed adjustment option. Press right paddle switch up to the ON
position.
6. When finished blending, set paddle switch to STANDBY position.
7. This blender is equipped with a PULSE option. Hold left paddle switch
in down position to engage PULSE function. Unit will run on max speed
(30,000 RPM) until the paddle switch is released.
8. Allow motor to come to a complete stop before removing container
from blender base. Never place the container on the motor base or
remove it from the motor base while motor is running.
9. Always hold container with one hand when starting and while blending.
Never operate without jar lid.
10. Wash and dry container after each use. See Cleaning and Sanitizing
Instructions.
MX REPROGRAMMABLE CONTROL SETTINGS
1. Before starting, make sure that the blender is unplugged and container
is not positioned on the blender.
2. Put ingredients into container and cover it. Do not fill above MAX line.
3. Place container on blender base. Be sure container is fully seated and
that drive coupling is properly engaged. Plug blender cord into outlet.
PREP