Waring FP40C - Manual (Page 17)

17
USE INSTRUCTIONS for ACCESSORY DISCS
in the CONTINUOUS FEED CHUTE FP40 & FP40C
• Assemble the bowl and accessory disc as instructed in the section titled, “Assembly of Batch Bowl Parts,”
page 8, or assemble the continuous feed chute and accessory disc as instructed in the section titled
“Assembly of Continuous Feed Chute Parts,” page 11.
• If required by your processing task, either:
• Stack the feed tube with food and position the large food pusher at the top
of the stack, or
• Place the large food pusher into the feed tube and remove the small feed pusher to use the
smaller feed chute located inside the large food pusher. This is described above, page 12.
Stack food items in the small food chute. Position small food pusher at the top of the stack.
• Be sure the unit is off by pushing and releasing the PULSE/OFF lever.
• Insert the power cord plug into a properly grounded outlet of the correct voltage.
• Use the ON switch for continuous processing, or the PULSE/OFF lever for pulsing/on-off
operation.
• Feed the items to be processed into the feed tube at a steady rate, using the food pusher to push the food
down. The same technique is used whether you choose to use the large pusher or the small pusher. Avoid
excessive force when using either one of the food pushers. Too much force may cause food items to jam in
the feed tube or damage the machine. ALWAYS USE THE LARGE FOOD PUSHER TO PUSH
FOOD ITEMS DOWN INTO THE LARGE FEED TUBE. IN THE SAME WAY, ALWAYS USE
THE SMALL FOOD PUSHER TO PUSH FOOD ITEMS DOWN INTO THE SMALL FEED
TUBE. NEVER PUT FINGERS, SPATULAS, OR OTHER UTENSILS INTO THE LARGE
FEED TUBE OR THE SMALL FEED TUBE CHANNEL.
• Never use the small food pusher in the large feed tube.
• When the bowl is full and/or you have finished your processing task with the bowl or continuous feed
chute, press the PULSE/OFF lever and let the processing disc come to a complete stop. Unplug the unit.
NEVER STOP THE FOOD PROCESSOR BY REMOVING THE PLUG FROM THE OUT-
LET OR BY REMOVING THE COVER. ALWAYS STOP THE UNIT BY PRESSING THE
“PULSE/OFF” SWITCH.
• Follow disassembly instructions for the bowl and continuous feed chute as appropriate. These are
described in the section titled “Disassembly of Batch Bowl Parts,” page 10, or the section titled
“Disassembly of Continuous Feed Chute Parts,” page 11.
When processing, it is recommended that the machine be operated on a 50% duty cycle, such as
5 minutes on/5 minutes off. This can be accomplished by processing for 5 minutes, then doing 5 minutes of
food preparation. Please remember to turn off the machine when not in use.