Waring 7015N - Manual (Page 2)

IMPORTANT SAFEGUARDS
When using electrical equipment basic safety precautions should
always be followed including the following:
1. READ ALL INSTRUCTIONS.
2. To protect against electrical hazards do not immerse the Blender
Base in water or other liquid.
3. Close supervision is necessary when any blender is used by or near
children.
4. Unplug from outlet when not in use, before putting on or taking off
parts, and before cleaning.
5. Avoid contacting moving parts.
6. Do not operate your blender with a damaged cord or plug or after the
appliance malfunctions or is dropped or damaged in any manner.
Return appliance to the nearest authorized service facility for
examination, repair or electrical or mechanical adjustment.
7. The use of attachments including canning jars not recommended by
the blender manufacturer may cause a risk of personal injury.
8. Do not use outdoors.
9. Do not let cord hang over edge of table or counter, or touch hot
surfaces.
10. Keep hands and utensils out of container while blending to prevent
the possibility of severe personal injury and/or damage to the
blender. A rubber scraper may be used but must be used only when
the blender is not running.
11. Blades are sharp. Handle carefully.
12. If your blender utilizes a removable Jar Base and Blade Assembly,
to avoid injury never place cutter assembly cutting blades on base
without container properly attached.
13. Always operate blender with cover in place.
14. When blending hot liquids, remove center piece of two-piece cover
on those units supplied with this construction. See Hot Blending
Instructions.
SAVE THESE INSTRUCTIONS
PRESET TIMER BLENDER
SPECIFICATIONS
• RATING 3.5A at 120VAC/50HZ (CATALOG NO. 7015)
1.5A at 230VAC/50HZ (CATALOG NO. 8015)
• AUTOMATIC Two preset timing intervals (15 seconds and 3 seconds) selectable via
TIMER
toggle switch on control panel. Timer can be bypassed for manual
operation
• BASE Die cast zinc and steel, baked enamel and chrome finish top.
• CONTAINER 48 ounce capacity Lexan polycarbonate jar with stainless steel blade,
two-piece plastic cover.
• CORD 6 foot, 18 gauge, three conductor grounded cord with strain relief.
• U.L. LISTED 120V models only.
CONTROL PANEL COMPONENTS
• MODE SELECTOR SWITCH Three position maintained contact toggle switch
located on right hand side of control panel, labeled AUTO/OFF/MANUAL;
selects desired operating mode.
• TIMING SELECTOR SWITCH Three position momentary contact toggle switch,
spring loaded to center position, located on left hand side of control panel,
labeled 15 SEC/3 SEC; selects desired timing interval.
• INDICATOR LAMP Neon pilot light; indicates when mode selector switch is in
either AUTO or MANUAL position.
OPERATION INSTRUCTIONS
1. Be sure mode selector switch is in the OFF (center) position.
2. Plug power cord into properly wired and grounded outlet.
3. For AUTOMATIC operation:
• Set mode selector switch to AUTO position. Indicator lamp will light.
• Momentarily move timing selector switch to position for time cycle desired.
Motor will run for interval selected, and stop automatically.
NOTE: Override of the automatic stop can be obtained by holding the timing selector
switch in position beyond the end of the preset interval. Motor will continue to run
until switch is released.
• When finished blending, return mode selector switch to OFF position. Indicator lamp
will extinguish.
4. For MANUAL operation:
• Set mode selector switch to MANUAL position. Indicator lamp will light, and motor
will run continuously.
• When finished blending, return mode selector switch to OFF position. Motor will stop
and indicator lamp will extinguish.
5. Unplug power cord from outlet when blender is not in use, before putting on or taking
off any parts other than container, and before cleaning.