Valco Baby Twin Latitude Peg Perego Adaptor - Manual (Page 4)

WARNINgs
•Always follow car seat manufacturer’s instructions when using the car seat.
•Be sure to check that all straps are securely fixed and in place before use.
• Check all parts for breakage or fatigue before use. Discontinue immediately if any part
is found to be damaged or broken.
• NEVER leave any child unattended at any time.
• This product is intended for use in North America only. It is not intended for use in
Australia.
• This product is intended for domestic use only. It is not intended for commercial use.
In North America only
www.valcobaby.com
1 800 610 7850
FIgURE I
20. Once your car seat is inserted, locate the remaining
set of straps.
21. Take the Male/Female strap and slip the strap
through the car seat belt hook on the side of the car
seat.
22. Repeat with the other strap.
23. Insert Male clip into its Female counterpart and
buckle.
24. Adjust straps to tighten around car seat.
25. you may want to readjust the recline of the seat
to ensure the car seat has the most comfortable and
secure ride.
TO REMOVE yOUR CAR sEAT:
26. Reverse the steps outlined in Figure I and lift out the
car seat.
TO REMOVE yOUR ADAPTOR:
27. slide all three connector pieces from the stroller,
undo the buckle under the footrest and remove adaptor.
NOTE: THERE Is NO NEED TO UNsCREW THE ADAPTOR.
RETAIN THE ADAPTOR IN THIs FORM FOR EAsy FUTURE
INsTALLATIONs.
I