Installing your peg perego car seat adaptor – Valco Baby Twin Latitude Peg Perego Adaptor User Manual

Page 2

INsTALLINg yOUR PEg PEREgO

CAR sEAT ADAPTOR

FIgURE A

1. Begin preparing the Latitude stroller for the Car

seat Adaptor by removing the canopy (hoods) from the

stroller and reclining the seats to their fully reclined

position (detailed instructions in the Twin Latitude

stroller Instruction Manual).

2. Remove the bumper bar, (detailed instructions in the

Twin Latitude stroller Instruction Manual).

3. Remove the extra hood and Peg Perego Adaptor

Bar from the packaging and dispose of packaging

responsibly.

FIgURE B

4. Prepare the Hood for installation by rotating the

hood rods so they are aligned with the corresponding

connector pieces on the stroller frame (where the twin

hood was connected.) (1)

NOTE: ENsURE THAT THE HOOD Is PLACED OVER THE

LEFT sEAT OF THE sTROLLER (WHEN FACINg yOU).

5. simultaneously slide the hood rods onto the

corresponding raised pieces on the stroller frame and

lock into place. (2)

Figure C

6. Align the Adaptor Bar connector piece with the

corresponding raised piece on the outer frame of the

stroller.

NOTE: BE sURE THAT THE ADAPTOR BAR Is IN ITs

UPRIgHT POsITION By PULLINg THE sUPPORT BAR

AWAy FROM THE ADAPTOR FRAME.

7. slide the Adaptor onto the corresponding raised piece

and lock into place.

NOTE: ONLy ONE sIDE OF THE ADAPTOR WILL sLIDE

ONTO THE sTROLLER FRAME. THE ADAPTOR WILL NOT

BE CONNECTED TO THE MIDDLE FRAME.

Figure D

8. Locate the middle hood connector piece.

9. Unscrew the screw, washer and nut from the middle

piece.

Hood

Seat Reclined

Adaptor Bar

Front View